Hi cineks,
there is another error:
Not connect direct to UART, but to GPIO4.
Take look at: 1-Wire-Slave-Baukasten V.2
1-Wire-Data -> GPIO4 of RPi (with resistor 4,7 to 3,3V RPi)
1-Wire-GND -> GND RPi
1-Wire-VCC -> 3,3V RPi
Then you must load the drivers:
modprobe w1-gpio
pullup=1modprobe w1-therm
If you use UART you need an adapter, for example DS2480 or DS2480B an other drivers.
Thank you for the files.
RoBue
there is another error:
Not connect direct to UART, but to GPIO4.
Take look at: 1-Wire-Slave-Baukasten V.2
1-Wire-Data -> GPIO4 of RPi (with resistor 4,7 to 3,3V RPi)
1-Wire-GND -> GND RPi
1-Wire-VCC -> 3,3V RPi
Then you must load the drivers:
modprobe w1-gpio
pullup=1modprobe w1-therm
If you use UART you need an adapter, for example DS2480 or DS2480B an other drivers.
Thank you for the files.
RoBue